SettingsSettings Subscribe  

NumisTip

Australia George V

1923  Half Penny reverse 1923  Half Penny obverse

1923 Half Penny

Mintage:1,113,600
Approximately 15,000 coins struck
Mint:Melbourne Monarch:George V Reverse Designer:W. H. J. Blakemore Obverse Designer:Sir E. B. MacKennel Size:25.5mm Weight:5.67g Edge:Plain Composition:97% Copper
2.5% Zinc
0.5% Tin

Values

Sales History

?

The 1923 half penny is the key date for the entire half penny series and represents the toughest financial challenge the half penny collector will face. The coin is desirable in all conditions with pitted and worn examples finding their place in budget half penny collections and pieces in AU50 or better often ending up in mid-range to high-end investment portfolios. While the 1923 half penny has a reasonably sizeable mintage of 1,113,600 coins being struck at the Sydney mint, these were dated 1922 and the 1923 mintage was actually struck at the Melbourne mint with a requested total of 480,000 coins (Sterling & Currency, 2008) . Despite this still relatively high mintage, only two dies were prepared for the Melbourne mint which should have been enough to strike about 150,000 coins but both dies formed cracks during the striking limiting the total mintage to a much lower figure. This was the first time the Melbourne mint attempted to strike half pennies and faults were bound to occur.

Obverse die cracks of a 1923 half penny Obverse die cracks of a 1923 half penny

Die cracks typically form around the left side of the obverse legend with pieces struck from a later die state tending to form cracks around the right side of both the obverse and reverse legend.

Reverse die cracks of a 1923 half penny Reverse die cracks of a 1923 half penny

Find out what dealers are paying with a subscription.

Subscribe now!

Find out what coins have actually sold for and where with a Standard/Professional subscription.

Subscribe now!